Havelock T, Teoh R, Laws D, Gleeson F; BTS Pleural Disease Guideline Group. Pleural procedures and thoracic ultrasound: British Thoracic Society Pleural Disease Guideline 2010. Thorax. 2010 Aug;65 Suppl 2:ii61-76. doi: 10.1136/thx.2010.137026. PubMed PMID: 20696688.
Pleural drainage is performed to remove air, blood, or fluid from the pleural cavity, to achieve lung expansion, and to correct mediastinal shift that may cause hemodynamic abnormalities. The procedure described below uses a chest drain. Emergency decompression of tension pneumothorax: see Pneumothorax. Decompression of pneumothorax using a syringe and catheter: see Pneumothorax. Thoracentesis: see Thoracentesis.
1) Primary spontaneous pneumothorax persisting (>2 cm on chest radiography) after aspiration using a catheter and syringe. Note that a larger amount of aspirated air (>2.5 L) may indicate ongoing air leakage.
2) Secondary or iatrogenic spontaneous pneumothorax, excluding asymptomatic patients with a small (<2 cm) pneumothorax.
3) Tension pneumothorax.
4) Bilateral pneumothorax.
5) Hemorrhagic pneumothorax (hemopneumothorax).
6) Mechanical ventilation–induced pneumothorax.
7) Posttraumatic pneumothorax in patients with penetrating chest injuries.
2. Pleural effusion:
1) Malignant (drainage combined with pleurodesis: see Exudative Pleural Effusion Caused by Malignancy).
2) Complicated parapneumonic effusion or empyema.
4) Pleural effusion following surgery, including thoracotomy, esophageal resection, or cardiac surgery.
Subcutaneous emphysema; infection of the pleural cavity, skin, or intercostal tissues; incorrect tube positioning; lung injury; visceral injury; hemothorax; lung edema following expansion (re-expansion pulmonary edema); intercostal nerve injury; Horner syndrome (very rare).
1. Confirm the diagnosis of pneumothorax or pleural effusion using appropriate imaging. Studies include chest radiography (if pneumothorax or anatomy is doubtful, perform computed tomography [CT] of the chest) and ultrasonography of the pleural cavity. If time permits, prior to procedure obtain complete blood count (CBC) (including platelet count), international normalized ratio (INR), activated partial thromboplastin time (aPTT), and blood group and screen.
2. Obtain informed consent.
3. If the procedure is elective (which is rarely the case) and the patient is receiving anticoagulant treatment, discontinue vitamin K antagonists and wait for the INR to decrease to <1.5; discontinue direct oral anticoagulants (DOACs) as before surgery with a high risk of bleeding (see Perioperative Direct Oral Anticoagulant Management). The last prophylactic dose of low-molecular-weight heparin (LMWH) should be administered ≥12 hours before the procedure and the last therapeutic dose of LMWH should be administered ≥24 hours before the procedure.
4. Insert a peripheral venous catheter.
5. Place the patient lying on the side opposite the planned procedure with an upper limb elevated on the side of the procedure. In the event that an apical pneumothorax requires drainage, positioning the patient in the supine position with the head-of-bed elevated to 45 degrees is appropriate.
1. Equipment for surgical field preparation, infiltration anesthesia, and short general anesthesia if necessary.
2. Chest drain and needle (bore 0.7-0.9 mm [22-20 gauge]) with syringe (10 or 20 mL). Small-bore chest drains are sometimes packaged in kits containing a needle and guidewire (as for central vein catheterization). Pigtail catheters are preferred to large bore chest tubesEvidence 1Weak recommendation (benefits likely outweigh downsides, but the balance is close or uncertain; an alternative course of action may be better for some patients). Moderate Quality of Evidence (moderate confidence that we know true effects of the intervention). Chang SH, Kang YN, Chiu HY, Chiu YH. A Systematic Review and Meta-Analysis Comparing Pigtail Catheter and Chest Tube as the Initial Treatment for Pneumothorax. Chest. 2018 May;153(5):1201-1212. doi: 10.1016/j.chest.2018.01.048. Epub 2018 Feb 13. PubMed PMID: 29452099. as they are associated with significantly lower risk of complications during insertion and shorter duration of drainage and hospital stay than large-bore chest tubes. In most nontraumatic pneumothoraces we prefer small-bore tubes (<14 F) if a chest tube is used.
3. If the chest drain is to be inserted using surgical technique, equipment for skin incision and dissection of the intercostal space is necessary. This includes scalpel, surgical and anatomical forceps, and blunt curved hemostat.
4. Suturing equipment: Needle holder, 1.0 needle with thread.
5. Three-chamber chest suction unit (fill the suction pressure-regulating chamber [typically to a level of 10-20 cm] and the underwater valve chamber [to the mark] with a sterile fluid: Figure 16.8-1), connecting tubing, and low-pressure suction unit if required (a central [wall or bedside panel vacuum port] or electric suction device).
Site of Chest Drain InsertionTop
Always insert the chest drain at the superior margin of the rib.
1. Pneumothorax: The fifth to eighth intercostal spaces in the mid-axillary line or the second intercostal space in the mid-clavicular line.
2. Nonencapsulated pleural effusion: The fifth to eighth intercostal spaces in the mid-axillary line.
3. Limited air or fluid collection: Depending on location determined using imaging studies and ultrasound guidance.
1. Use ultrasonography, if available, to guide chest tube insertion.
2. Prepare the surgical field and perform local anesthesia. IV conscious sedation is useful (see Procedural Sedation and Analgesia).
3. Puncture the pleural cavity using a syringe and needle (see Thoracentesis) to confirm the presence of air or fluid.
4. To insert a small-bore chest drain, use the Seldinger technique (pass a guidewire through the needle into the pleural cavity, withdraw the needle, dilate skin and intercostal soft tissue by a dilator, then remove the dilator, insert a chest drain over the guidewire, and finally remove the guidewire). When using larger-bore tubes, make a ~1.5 to 2 cm skin incision at the level of the upper edge of the rib and dissect the intercostal tissue. Once the pleural cavity is entered (ie, the parietal pleura is penetrated), place a mattress stay suture. In patients with pneumothorax advance the chest drain towards the apex of the lung; in patients with pleural effusion advance the chest drain towards the base of the lung. If the chest drain is fitted with a trocar, withdraw the trocar ~1 cm within the tube before attempting chest drain insertion. Chest drains used for pleural effusion should optimally be inserted under imaging guidance. After insertion do not evacuate >1.5 L of fluid per hour.
5. Connect the tube to the one-way valve suction unit (Figure 16.8-1). If active suction devices are used, the negative pressure should be from −10 to −20 cm H2O.
6. Secure the chest drain to the chest wall with suturing.
After the ProcedureTop
1. Check the position of the chest drain on chest radiography.
2. Monitor evacuated fluid volumes. Check for evacuation of air from the pleural cavity (this is evidenced by air bubbles in the suction unit chamber [usually the middle chamber] fitted with an underwater seal valve). Make sure the suction system is airtight. Do not clamp the chest drain when air bubbles are seen inside or a drain is inserted for the treatment of pneumothorax.
3. Tube removal:
1) Indications: No airflow in the chest drain, complete lung expansion confirmed by chest radiographs (also after conversion from active to passive suction [eg, disconnection of the 3-chamber collection from suction]) for a period of several hours. The volume of fluid drained from the pleural cavity should be <200 mL/24 h.
2) Technique: Cut the securing suture. Instruct the patient to perform the Valsalva maneuver (ie, forced expiration with closed airway). Withdraw the chest drain at the time of the maneuver using a quick motion and immediately tie the stay suture to seal the tube track.
Figure 16.8-1. A 3-bottle chest drainage system.